R3765/67G Series Network Analyzer Operation Manual
6.2 Using the Save/Recall Register
6-5
6.2 Using the Save/Recall Register
Here describes how to save/recall the setting of the measurement to the save/recall-register.
(1) Saving into the save-register
Set the measurement screen to save by displaying the markers, etc.
Save the setting in the save-register.
[SAVE] {SAVE REGISTER} {SAVE REG-1}
By the above operation, the display on the screen changes as follows.
Figure 6-5 Saving into the Save-Register
1
2
To Next Page
Loading...
