ADVANTEST R3765G Series User Manual

R3765/67G Series Network Analyzer Operation Manual
7.15 Hard Copy
7-155
Setting R9833 DIP switches
The DIP switches should be set to the standard values as shown in Figure 7-21. These
switched are used to set the initial conditions at powering on and the interface
conditions.
Figure 7-21 Setting DIP Switches
Table 7-3 DSW1 Function
SW No. Functions (ON = 1) Standards
1 to 3
Paper size setting (SW3 = 0) (SW3 = 1) SW1 = 0
SW2 = 1
SW3 = 0
A4 long side way
4
Setting rotational coordinates 1 : rotational coordinates ON 0
5
Selection of unit length for step number 0 : normal 1 : switch 0
6
Paper detection disable 0 : with paper detection function
1 : not with paper detection function
0
7
Switching input buffer capacity 1 : maximum (12KB) 0 : 1KB 0
8
FP-GL-I/FP-GL-II select 1 : FP-GL-I 0 : FP-GL-II 1
5
⇒
ON
DSW1
1
2
3
4
5
6
7
8
OFF
ON
⇒
ON
DSW2
OFF
ON
DSW1 :
HP mode when SW No.8 is ON.
FP-GL mode when SW No.8 is OFF.
In AT mode, it is required to set OFF SW
No.8 and ON SW No.4. (Refer to Table 7-3.)
DSW2 :
Sets the plotter address to 5. (Refer to Table
7-4.)
1
2
3
4
5
6
7
8
SW1 SW2 ISO/JIS ANSI
0
1
0
1
0
0
1
1
A3 maximum width and depth
A3 long vertical way direction filling up
A4 long side way direction filling up
A4 long vertical way direction filling up
B maximum width and depth
B long vertical way direction filling up
A long side way direction filling up
A long vertical way direction filling up

ADVANTEST R3765G Series Specifications

General

Brand	ADVANTEST
Model	R3765G Series
Category	Measuring Instruments
Language	English