ADVANTEST R3765G Series

R3765/67G Series Network Analyzer Operation Manual
A.4 Soft Key Menu List
A-15
[AVG]
{AVG STATE ON/OFF}
{AVG COUNT}
{AVG RESTART}
{GROUP DELAY APERTURE}
{SMOOTHING ON/OFF}
{SMOOTHING APERTURE}
{TRACE ON/OFF}
{IF RBW [ ]}
{NORMALIZE (THRU)}
{NORMALIZE (SHORT)}
{CAL MENU}
{CORRECT ON/OFF}
{INTERPOLATE ON/OFF}
{PORT EXTENSION}
{ZO VALUE}
{More 1/2}
{ELEC DELAY ON/OFF}
{ELECTRICAL DELAY}
{ELECTRICAL LENGTH}
{VELOCITY FACTOR}
{PHASE OFFSET VALUE}
{PHASE SLOPE}
{TRACE 2nd/1st}
{More 2/2}
{1PORT FULL CAL}
{2PORT CAL MENU}
* 7
{3PORT FULL CAL}
*8
{AUTO CAL} *9
{CLEAR CAL DATA}
{CAL KIT [ ]}
{Return}
{EXTENSION ON/OFF}
{EXTENSION INPUT A}
{EXTENSION INPUT B}
{EXTENSION INPUTC}
* 8
{EXTENSION PORT 1}
{EXTENSION PORT 2}
{EXTENSION PORT 3}
* 8
{MARKER
→
EXTENSION}
{Return}
{2 PORT FULL CAL}
{NORMALIZE&ISOL’N}
{Return}
{REFLEC’N}
{TRANSMISSION}
{ISOLATION}
{DONE 2-PORT}
{OPEN}
{SHORT}
{LOAD}
{DONE 1-PORT}
{THRU}
{ISOLATION}
{DONE NORM & ISO}
* 7: For the R3765CG/67CG
* 8: For the R3765CG/67CG with OPT11 installed
* 9: Refer to R17050 Automatic Calibration Kit Manual.
{YES}
{NO}
To (1)
on the next page
[CAL]
{OMIT ISOLATION}
{FWD. ISOL’N}
{REV. ISOL’N}
{DONE ISOLATION}
{S11(PORT1) FWD:OPEN}
{S11(PORT1) FWD:SHORT}
{S11(PORT1) FWD:LOAD}
{S22(PORT2) REV:OPEN}
{S22(PORT2) REV:SHORT}
{S22(PORT2) REV:LOAD}
{DONE REFLECT’N}
{FWD. TRANS THRU}
{FWD. MATCH THRU}
{REV. TRANS THRU}
{REV. MATCH THRU}
{GROUP THRU}
{DONE TRANS}
To (2)
on the next page
{EXTENSION ON/OFF}
{EXTENSION PORT 1}
{EXTENSION PORT 2}
{EXTENSION PORT 3}
{EXTENSION PORT 4}
{MARKER
→
EXTENSION}
{Return}
For OPT14