Run the no ip address command in Global Configuration command mode.
The following table describes the parameters for this command.
Table 50: no ip address parameters
Parameters Description
stack | switch Zeroes out the stack IP address and subnet mask or the switch
IP address and subnet mask.
unit Zeroes out the IP
address for the specified unit.
Important:
When you change the IP address or subnet mask, connectivity to
Telnet and the Web
Interface can be lost. Any new Telnet connection can be disabled and must connect to the
serial console port to configure a new IP address.
show ip address source command
The show ip address source command displays the configured boot mode for the next
switch reboot.
The syntax for the show ip address source command is
show ip address source
Run the show ip address source command in User EXEC or Privileged EXEC command
mode.
ip dhcp client lease command
The ip dhcp client lease command configures the DHCP client lease time in seconds,
minutes, hours, days, and weeks.
The syntax for the ip dhcp client lease <time> command is
ip dhcp client lease
Run the ip dhcp client lease command in Global Configuration command mode.
The following table describes the parameters for the ip dhcp client lease command.
Table 51: ip dhcp client lease parameters
Variable Value
<time> Specifies the DHCP client lease time. Values include:
System configuration using ACLI
134 Configuration — System April 2011
To Next Page
Loading...
