The syntax for the show ip dhcp client lease command is
show ip dhcp client lease
Run the no ip dhcp client lease command in User EXEC or Privileged EXEC command
mode.
renew dhcp command
The renew dhcp command renews the DHCP client lease.
The syntax for the renew dhcp command is
renew dhcp
Run the renew dhcp command in Global Configuration command mode.
ip default-gateway command
The ip default-gateway command sets the default IP gateway address for a switch or a
stack to use.
The syntax for the ip default-gateway command is
ip default-gateway <XXX.XXX.XXX.XXX>
Run the ip default-gateway command in Global Configuration command mode.
The following table describes the parameters for the ip default-gateway command.
Table 52: ip default-gateway parameters
Parameters Description
XXX.XXX.XXX.XXX Enter the dotted-decimal IP address of the default IP gateway.
Important:
When you change the IP gateway, connectivity to Telnet and the Web Interface can be
lost.
no ip default-gateway command
The no ip default-gateway command sets the IP default gateway address to zero (0).
The syntax for the no ip default-gateway command is
no ip default-gateway
System configuration using ACLI
136 Configuration — System April 2011
To Next Page
Loading...
