Avaya 4526FX - Page 152

sntp server primary address [<ipv6_address> | <A.B.C.D>]
Run the SNTP server primary address command in Global Configuration command
mode.
The following table describes the parameters for this command.
Table 67: SNTP
server primary address parameters
Parameters and
Variables
Description
ipv6_address Enter the IPv6 address of the primary NTP
server.
<A.B.C.D> Enter the IP address of the primary NTP server in dotted-
decimal notation.
SNTP server secondary address command
The SNTP server secondary address command specifies the IP addresses of the
secondary NTP
server.
The syntax for the SNTP server secondary address command is
sntp server secondary address [<ipv6_address> | <A.B.C.D>]
Run the SNTP server secondary address command in Global Configuration command
mode.
The following table describes the parameters for this command.
Table 68: SNTP server secondary address parameters
Parameters Description
ipv6_address Enter the IPv6 address of the secondary NTP server.
<A.B.C.D> Enter the IP address of the secondary NTP server in dotted-
decimal notation.
No SNTP server command
The no SNTP server command clears
the NTP server IP addresses. The command clears
the primary and secondary server addresses.
The syntax for the no SNTP server command is
no sntp server {primary | secondary}
Run the no SNTP server command in Global Configuration command mode.
System configuration using ACLI
152 Configuration — System April 2011