The following table describes the parameters for this command.
Table 69: no SNTP server parameters
Parameters Description
primary Clear the primary SNTP server address.
secondary Clear the secondary SNTP server address.
SNTP sync-now command
The SNTP sync-now command forces a manual synchronization with the NTP server
.
The syntax for the SNTP sync-now command is
sntp sync-now
Run the SNTP sync-now command in Global Configuration command mode.
Important:
SNTP must be enabled before this command can take ef
fect.
SNTP sync-interval command
The SNTP sync-interval command specifies recurring synchronization with the secondary
NTP server in hours relative to initial synchronization.
The syntax for the SNTP sync-interval command is
sntp sync-interval <0-168>
Run the SNTP sync-interval command in Global Configuration command mode.
The following table describes the for this command.
Table 70: SNTP sync-interval parameters
Parameters and
Variables
Description
<0-168> Enter
the number of hours for periodic synchronization with the
NTP server.
Important:
0 is boot-time only, and 168 is once a week.
General switch administration using ACLI
Configuration — System April 2011 153
To Next Page
Loading...
