The following sections describe configuring CANA using ACLI:
• Configuring CANA on page 158
• Viewing current auto-negotiation advertisements on page 158
• Viewing hardware capabilities on page 158
• Setting default auto-negotiation-advertisements on page 158
• no auto-negotiation-advertisements command on page 159
Configuring CANA
Use the auto-negotiation-advertisements command to configure CANA.
To configure port 5 to advertise the operational mode of 10 Mb/s and full duplex enter the
following command:
auto-negotiation-advertisements port 5 10-full
Viewing current auto-negotiation advertisements
To view the autonegotiation advertisements for the device, enter the following command:
show auto-negotiation-advertisements [port <portlist>]
Viewing hardware capabilities
To view the available operational modes for the device, enter the following command:
show auto-negotiation-capabilities [port <portlist>]
Setting default auto-negotiation-advertisements
The default auto-negotiation-advertisements command makes a port advertise
all auto negotiation capabilities.
The syntax for the default auto-negotiation-advertisements command is
default auto-negotiation-advertisements [port <portlist>]
To set default advertisements for port 5 of the device, enter the following command:
default auto-negotiation-advertisements port 5
Run the default auto-negotiation-advertisements command in Interface
Configuration mode.
System configuration using ACLI
158 Configuration — System April 2011
To Next Page
Loading...
