Avaya 4526FX - Page 319

Field Description
If you select untagged, the system ignores
the VLAN ID and priority values, and
recognizes only the DSCP value.
Editing LLDP MED policies using EDM
Use this procedure to edit a previously configured LLDP MED policy for the local system.
Procedure steps
1.
From the navigation tree, double-click Edit.
2. In the Edit tree, double-click Diagnostics.
3. In the Diagnostic tree, double-click 802.1AB.
4. In the 802.1AB tree, double-click Port MED.
5. To select a policy to edit, click the PortNum.
6. In the policy row, double-click the cell in thePolicyVlanID column.
7. Select a VLAN from the list.
8. Click Ok .
9. In the policy row, double-click the cell in thePolicyPriority column.
10. Edit the policy priority value.
11. In the policy row, double-click the cell in thePolicyDscp column.
12. Edit the policy DSCP value.
13. In the policy row, double-click the cell in thePolicyTagged column.
14. Select a value from the list.
15. Click Apply .
Variable definitions
Use the data in the following table to edit a previously configured LLDP MED policy for the
local system.
Variable Value
PortNum Indicates the port on which to configure
LLDP MED policies.
This is a read-only cell.
PolicyAppType Indicates the policy application type. This is
a read-only cell.
• voice— voice network policy
• voiceSignaling— voice signalling network
policy
LLDP Port MED configuration using EDM
Configuration — System April 2011 319