Variable Value
PolicyVlanID Specifies the VLAN identifier for the selected
port or ports. Values range from 1–4094. If
you
select priority tagged frames, the system
recognizes only the 802.1p priority level and
uses a value of 0 for the VLAN ID of the
ingress port.
PolicyPriority Specifies the value of the 802.1p priority that
applies to the selected switch port or ports.
Values range from 0–7. The default value is
6.
PolicyDscp Specifies the value of the Differentiated
Service Code Point (DSCP) as defined in
IETF RFC 2474 and RFC 2475 that is
associated with the selected switch port or
ports. Values range from 0–63. The default
value is 46.
PolicyTagged Specifies the type of VLAN tagging to apply
on the selected switch port or ports.
• true—uses a tagged VLAN
• false—uses an untagged VLAN or does
not support port-based VLANs.
If you select untagged, the system ignores
the VLAN ID and priority values, and
recognizes only the DSCP value.
Deleting LLDP MED policies using EDM
Use this procedure to delete a LLDP MED policy
.
Procedure steps
1. From the navigation tree, double-click Edit.
2. In the Edit tree, double-click Diagnostics.
3. In the Diagnostic tree, double-click 802.1AB.
4. In the 802.1AB tree, double-click Port MED.
5. In the work area, click the Local Policy tab.
6. To select a policy to delete, click the PortNum.
7. Click Delete .
System configuration using Enterprise Device Manager
320 Configuration — System April 2011
To Next Page
Loading...
