Important
• Cut the edge of the roll paper if it is uneven, dirty, or has tape residue. Otherwise, it may cause feeding
problems and affect the printing quality. Be careful not to cut through any barcodes printed on the roll.
• Align the edges of the paper on both ends of the roll. This may cause feeding problems.
Caution
• Set
the roll on a table or other flat surface so that it does not roll or fall. Rolls are heavy, and dropping a
roll may cause injury.
Note
• For details on supported sizes and types of rolls, see Paper Sizes or the Paper Reference Guide. (See
"Paper Sizes.") →P.581 (See "Types of Paper.") →P.578
• After pressing the Load/Eject button, you can refer to instructions on the Display Screen as you load the
paper.
1. Lift
the Holder Stopper lever (a) from the shaft side to unlock it. Holding the Holder Stopper at the position
indicated (b), remove it from the Roll Holder.
Handling Paper
>
Handling rolls
>
iPF825 Attaching the Roll Holder to Rolls
7
585
To Next Page
Loading...
