Pro Tools Reference Guide654
8 From the Auxiliary Input track’s Output Path
selector, select an output path (main outputs).
Adjust the individual track faders to balance the
dry (unprocessed) tracks. With the send set to
pre-fader, the amount of effect is controlled by
the level of the Send Level fader or the Auxiliary
Input Volume fader. If the send is post-fader, the
Send Level fader follows volume level.
Send and Return Submixes with
External Devices
To create an effects return submix with an
external device:
1 Assign each track’s main output to your main
mix outputs.
2 Assign a send (mono or stereo) and set the
send destinations on the source tracks to the
output path connected to the external device.
Configure the sends for pre- or post-fader, as
needed.
3 Choose Track > New.
4 Specify the track type (Aux Input) and format
(stereo or mono), then click Create.
5 From the Auxiliary Input track’s Input Path se-
lector, select the input path connected to the ex-
ternal device.
6 From the Auxiliary Input track’s Output Path
selector, select an output path (main outputs).
Send/return setup for a plug-in or hardware insert
Send to effect bus
Input set to send bus path
Output set to main mix outs
Controls level of dry signal
Controls level of effect return
Effect (plug-in or hardware)
Insert
Controls level of send to effects bus
To Next Page
Loading...