Emotron VS10 - Page 357

In the following, all parameters relevant for the sequence configuration are given.
If the sequencer is active, write accessed to all parameters are blocked that
concern the active sequence configuration!
Parameter
Name / value range / [default setting]
Info
0x4030:001
(P830.01)
Sequence 1: Step 1
(Sequence 1: Step 1)
Configuration of the steps 1 ... 16 for sequence 1.
Alternatively to calling a single segment, a complete sequence (with a
higher number) can also be called from one step. This, for instance,
serves to configure a main sequence from which several
subsequences are called successively.
With the setting "0", the respective step is skipped.
-8
Sequence 8
-7
Sequence 7
-6
Sequence 6
-5 Sequence 5
-4
Sequence 4
-3
Sequence 3
-2
Sequence 2
0
Skip step
1 Segment 1
2
Segment 2
3
Segment 3
4
Segment 4
5
Segment 5
6 Segment 6
7
Segment 7
8
Segment 8
0x4030:002
(P830.02)
Sequence 1: Step 2
(Sequence 1: Step 2)
For further possible settings, see parameter
0x4030:001 (P830.01).  340
0
Skip step
0x4030:003
(P830.03)
Sequence 1: Step 3
(Sequence 1: Step 3)
For further possible settings, see parameter
0x4030:001 (P830.01).  340
0
Skip step
0x4030:004
(P830.04)
Sequence 1: Step 4
(Sequence 1: Step 4)
For further possible settings, see parameter
0x4030:001 (P830.01).

340
0
Skip step
0x4030:005
(P830.05)
Sequence 1: Step 5
(Sequence 1: Step 5)
For further possible settings, see parameter
0x4030:001 (P830.01).

340
0 Skip step
0x4030:006
(P830.06)
Sequence 1: Step 6
(Sequence 1: Step 6)
For further possible settings, see parameter
0x4030:001 (P830.01).

340
0
Skip step
0x4030:007
(P830.07)
Sequence 1: Step 7
(Sequence 1: Step 7)
For further possible settings, see parameter
0x4030:001 (P830.01).  340
0
Skip step