Emotron VS10 - Page 360

360 01-6203-01R3, CG Drives & Automation
Parameter
Name / value range / [default setting]
Info
0x4032:012
(P835.12)
Sequence 2: Step 12
(Sequence 2: Step 12)
For further possible settings, see parameter
0x4032:001 (P835.01).

342
0 Skip step
0x4032:013
(P835.13)
Sequence 2: Step 13
(Sequence 2: Step 13)
For further possible settings, see parameter
0x4032:001 (P835.01).  342
0
Skip step
0x4032:014
(P835.14)
Sequence 2: Step 14
(Sequence 2: Step 14)
For further possible settings, see parameter
0x4032:001 (P835.01).  342
0
Skip step
0x4032:015
(P835.15)
Sequence 2: Step 15
(Sequence 2: Step 15)
For further possible settings, see parameter
0x4032:001 (P835.01).  342
0
Skip step
0x4032:016
(P835.16)
Sequence 2: Step 16
(Sequence 2: Step 16)
For further possible settings, see parameter
0x4032:001 (P835.01).

342
0
Skip step
0x4033
(P836.00)
Number of cycles sequence 2
(Cycl. sequence 2)
1 ... [1] ... 65535
From version 03.00
Definition of how often the sequence 2 is to be passed through.
1 = one pass, 2 = two passes, ...
65535 = infinite number of cycles.
0x4034:001
(P840.01)
Sequence 3: Step 1
(Sequence 3: Step 1)
Configuration of the steps 1 ... 16 for sequence 3.
Alternatively to calling a single segment, a complete sequence (with a
higher number) can also be called from one step. This, for instance,
serves to configure a main sequence from which several
subsequences are called successively.
With the setting "0", the respective step is skipped.
-8 Sequence 8
-7
Sequence 7
-6
Sequence 6
-5
Sequence 5
-4
Sequence 4
0
Skip step
1
Segment 1
2
Segment 2
3
Segment 3
4
Segment 4
5 Segment 5
6
Segment 6
7
Segment 7
8
Segment 8
0x4034:002
(P840.02)
Sequence 3: Step 2
(Sequence 3: Step 2)
For further possible settings, see parameter
0x4034:001 (P840.01).

343
0
Skip step
0x4034:003
(P840.03)
Sequence 3: Step 3
(Sequence 3: Step 3)
For further possible settings, see parameter
0x4034:001 (P840.01).

343
0
Skip step