Emotron VS10 - Page 481

Error code
Info
Error type
Adjustable in
dec
hex
Keypad display
Error message
24979 0x6193 PU comm error PU: communication error Fault -
If this error occurs, the motor may not be able to be brought to standstill anymore. If
communication is lost completely, the power output stage will switch off.
Notes:
Serious error: The inverter is inhibited immediately. The motor becomes torqueless
(coasts).
24980
0x6194
PU SDO comm err.
SDO communication with PU aborted
Fault
-
Notes:
Serious error: The inverter is inhibited immediately. The motor becomes torqueless
(coasts).
24981
0x6195
I2C conn. error
I2C connection lost
Warning
-
Notes:
Logging only (Error history buffer/Logbook)
24982
0x6196
I2C bus error
I2C bus error
Warning
-
Notes:
Logging only (Error history buffer/Logbook)
25008 0x61B0 PU uC supply err PU: uC supply voltage drop down Fault -
A supply voltage drop for the microprocessor of the power unit has been detected.
25009
0x61B1
PU general error
PU: general error
Fault
-
Notes:
Serious error: The inverter is inhibited immediately. The motor becomes torqueless
(coasts).
25216
0x6280
P400 config err
Trigger/functions connected incorrectly
Trouble
-
The assignment directives have not been observed:
If the "flexible I/O configuration" is active as control source, the "Enable inverter"
func
tion or the "Run" function must be connected to a digital input in order that the
motor can be stopped again any time!
In case of keypad or network control, the two functions "Enable inverter" and "Run" can
also be set to "Constant TRUE [1]" to start the motor.
The use of the "Start forward (CW)" and "Start reverse (CCW)" functions excludes the
use of the "Run forward (CW)" and "Run reverse (CCW)" and vice versa.
 Start / stop motor

363
25217
0x6281
User fault 1
User-defined fault 1
Fault
-
The "Activate fault 1" function was triggered via the flexible I/O configuration.
The error can only be reset after the function has been deactivated again.
 Triggering a user-defined fault

406
25218
0x6282
User fault 2
User-defined fault 2
Fault
-
The "Activate fault 2" function was triggered via the flexible I/O configuration.
The error can only be reset after the function has been deactivated again.
 Triggering a user-defined fault

406
25232
0x6290
Invert rotation
Warning invert rotation
Warning
-
The "Invert rotation" function was requested with an active limitation of rotation.
Motor
rotating direction  153
Notes:
Logging only (Error history buffer/Logbook)
25233
0x6291
Trouble overflow
Maximuml allowed troubles exceeded
Fault
-

Automatic restart
 314
25248
0x62A
0
AC Dr. UserFault
AC Drive: user fault
Fault
-
The "Activate fault" function was triggered via the AC drive control word.
The error can only be reset after the function has been deactivated again.
25249
0x62A1
Netw.UserFault 1
Network: user fault 1
Fault
-
The "Activate fault 1" function was triggered via the NetWordIN1 data word.
The error can only be reset after the function has been deactivated again.
 Further process data  191
25250
0x62A
Netw.UserFault 2
Network: user fault 2
Fault
-