EnerSys Alpha Cordex CXC HP User Manual

Cordex®CXCHPControllerSoftwareManual|12-ACsourcesystems
Notice: The rectifier mapping can also be changed one-by-one for each rectifier, in the Systems
> DC System > Inventory > Rectifiers > Phase Mapping table.
Notice: The rectifiers can also be assigned to a particular phase. This can be done through the
System > DC System > Inventory > Rectifiers > Phase Mapping table.
Rectifiers that are left at the default setting of No Phase will be assumed to belong to Phase 1.
If a rectifier has been set to a phase that does not exist, that rectifier’s voltage values will not be
included in the voltage calculations for the AC source.
0350058-J0 Rev AL Page 139

EnerSys Alpha Cordex CXC HP Specifications

General

Brand	EnerSys
Model	Alpha Cordex CXC HP
Category	Controller
Language	English