EnerSys Alpha Cordex CXC HP - Scheduler

Cordex®CXCHPControllerSoftwareManual|22-Usingcustomviews,data,timers,counters,scheduler,andcustomactions
• Initialize Source: ThisoptionalfieldisusedtorepresenttheInitialize value.Itisusuallysettothe
resultofacustomdata.
• Initial Value: TheinitialvalueoftheDown Counter.
Therearealsosomefieldstodescribethestateofthecounter:
•
Input: ThevalueofthefieldthatwasselectedfortheInput Source.Itwillevaluatetofalseortrue.
•
Output: Thevalueofthecounter.
• Initialize: ThevalueofthefieldthatwasselectedfortheInitialize Source.Itwillevaluatetofalse
ortrue.
• Counter at Zero: ThisvalueistruewhenthecounterOutput isequaltozero.
ThecounteralsohasaReinitialize Counter button.Whenthisbuttonispressed,thecounterOutput is
setbacktotheinitialvalue.
Down counter operation
Thedowncounteroperatesasfollows:
• WhentheInput valuegoesfromfalsetotrue,theOutput willdecrementbyone,aslongasitis
greaterthanzeroandtheInitialize valueisfalse.
• WhentheInitialize valueistrue,theOutput willalwaysbeequaltotheInitial Value.
• TheCounter at Zero valuewillbetruewhenevertheOutput isequaltozero.
• WhentheReinitialize Counter buttonispressed,thecounterOutput issettotheInitial
Value.ThisallowsforamanualresetofthecounterincasetheInitialize Source hasnotbeen
configured.
22.5. Scheduler
TheScheduler featuremakesitpossibletocreateactionswhichcanoccurorrecuratspecifictimesor
dates.Withthisfeatureyoucan:
• Scheduleasingleaction.
• Schedulearecurringaction,hourly,daily,weekly,ormonthly.
TheScheduler canbeusedtodothefollowing:
• EqualizethebatteriesonaDCsystem.
• RunabatterytestonaDCsystem.
• PutaDCsystembackintofloatmode(cancelinganyequalizeorbatterytest).
0350058-J0 Rev AL Page 249