EnerSys Alpha Cordex CXC HP - Line Power System Layout; Use the Layout Screen to View Module Status

Cordex®CXCHPControllerSoftwareManual|8-Linepowersystems
Notice: To assign channels to a load, refer to the section on Line power system layout or
Configure line power system channels.
To configure LPS loads:
1. GotoSystems > Line Power System > Inventory > Line Power Loads.Youwillseeatablefor
loadsinthesystem.Thistableshowshowmanychannelsareassignedtotheloadandtheloads
totaloutputcurrentandpower.Addorremoveloadsfromthisscreen.
2. SelecttheGO TO buttonfortheloadyouwanttoconfigure.
3. IntheConfiguration table,assigntheloadanameandadescription.Werecommendthatyou
assigntheloadanamethatrepresentstheactualload.
4. Configuretheloadalarmsasneeded.
8.7. Line power system layout
ThelinepowersystemLayout screenshowsagraphicalviewbasedontheshelfandslotIDasreported
bythelinepowermodules.Thisviewallowsaconvenientwaytoviewmodulestatusandtoconfigureand
interactwithindividualchannels.
8.7.1. Use the layout screen to view module status
ThelinepowerLayout screenprovidesaconvenientwaytoview:
•
Moduleshelfandslotposition
•
Outputvoltage,powerandcurrentforeachmodule
• Moduleandchannelalertstatus
•
Moduleandchannelinformation(detailed)
• Loadinformation(detailed)
How to use the Layout screen to view module and channel status:
1.
GotoSystems > Line Power System > Layout.Thisscreenshowsagridoflinepowermodules
organizedbyshelfIDvertically,andslotIDhorizontally.Eachmoduleisrepresentedbyarectangle
showingtheoutputvoltageandtheoutputpowerforeachchannel.Theinformationinthe
rectangleisgreentoindicatethatamoduleisoperatingnormally.
Itispossibletodisplaychanneloutputpowerorchanneloutputcurrentonthisscreen.Changethe
Primary Output Display tothedesiredvalueintheSystem Properties tableatSystems > Line
Power System > Configure System.
Page 118 0350058-J0 Rev AL