EnerSys Alpha Cordex CXC HP - Figure 4-23 Shelf Layout Menu

Cordex®CXCHPControllerSoftwareManual|4-Gettingstarted
Figure 4-23 Shelflayoutmenu
FromtheShelf Layout youcanselectanyofthedevicestobetakentothedevicedetailspage.
ThefollowingmodulessupporttheShelf Layout function:
•
Cordex®HP12kW48Vdcrectifiersystem
•
Cordex®HPLPS36linepowersystem
• Cordex®HPeLimiter+distributionsystem
•
Alpha®InverterModule(AIM)2500
IfallthedevicesinasystemdonothavebayID,shelfID,andslotIDinformationthentheviewwillswitch
toasimpletablewitheachdeviceonaseparaterow.
Refertoyourdevicemanualtodeterminewhetheryourdevicessupportthisfeature.
4.3.4.8.1.Configureshelflayoutmanually
IfdevicesdonotprovidebayID,shelfID,slotIDinformationthentheConfigure Shelf Layout feature
canbeusedtomanuallyconfigurealayout.OntheShelf Layout page,aConfigureShelfLayoutlinkis
providedforDCsystemsandconvertersystems.IfallthemodulesofyoursystemhavebayID,shelfID,
andslotIDinformation,thebuttonwillappearontopofthesystem’sshelflayout.Otherwisethebuttonwill
appearonthesimpletableofmodules.
To map your modules to the Shelf Layout:
1. SelectConfigure Shelf Layout toopentheConfigure Shelf Layout page
2. Onthemoduleyouwishtomap,selecttheLocate button.ThephysicalmoduleLEDwillbeginto
blink.
3. Onyourphysicallayout,locatetheblinkingmoduleandmakeanoteoftheslotposition.
4.
OntheShelf Layout page,dragthemoduletotheappropriateshelf/slotpositiononthelayout
grid.
0350058-J0 Rev AL Page 57