Cordex®CXCHPControllerSoftwareManual|20-Maintainingthecontroller
To restart the controller from the web interface:
1. FromthemaindashboardgotoController > About > General.
2. SelecttheRestart Controller button.
3. SelectRestart whenprompted.
4. TheController Restart windowdisplaysprogressviaaprogressbar.
5. Thecontrollerscreengoesblack,andtheLEDscyclewhilerestartisinprogress.
Oncecomplete,theloginpagedisplaysonthewebinterface,andtheCordex®HPlogodisplaysonthe
controller.
20.3.2. Restart the controller via the LCD
Notice: Ensure that the controller software or operating system software is not being updated.
TorestartthecontrollerviatheLCD:
1. Fromthemaindashboardofthecontroller,selectShortcuts,thenselectRestart.
2. SelecttheExecute buttontoconfirm.
Thefrontscreenblacksout,andtheLEDstatuslightscycleuntiltherestartiscomplete.Oncetherestart
completes,theCordex®HPlogodisplays.
20.3.3. Powering down the controller
Sometimesitmaybenecessarytopowerdownthecontrollertoreplace,remove,orrepairrectifiers.
Notice: You must use the LCD or web interface to reset the controller. This ensures that recent
changes and files are saved properly.
1. Fromthemaindashboardonthewebinterface,gotoController > About > General andthen
selectcontrollerreset.
-or-
2. FromthemaindashboardontheLCD,selectShortcuts,thenselectReset.
3. SelectExecute toconfirm.
4.
WhilethecontrollerLEDsareperformingachasepattern,powerdownthecontrollerbyremoving
thepowerpinontheright-sideofthecontroller.
Afterareset,thecontrollerLEDswillperformachasepatternthatindicatesthatthecontrolleris
booting.Itissafetoremovepowerwhilethecontrollerisbooting.Oncethatchasepatternstops,
thebootsequenceisoveranditisnolongersafetoremovepower.
0350058-J0 Rev AL Page 185