RX300 S7
Upgrade and Maintenance Manual 119
Power supply
Ê "Locating the defective server" on page 56
6.1.3 Removing a PSU dummy module
Figure 27: Removing the PSU dummy module
Ê Press in on both locking latches on the PSU dummy module (1) and carefully
detach the dummy module from its slot (2).
Ê Remove the dummy module from its slot.
V CAUTION!
Keep the dummy cover for future use. If a power supply module is
removed and not immediately replaced by a new one, a PSU dummy
cover must be replaced in the slot to comply with applicable EMC
regulations and satisfy cooling requirements.
To Next Page
Loading...
