RX300 S7
Upgrade and Maintenance Manual 211
Expansion cards and backup units
9.3.3.3 Removing the defective SAS RAID controller
Ê "Removing the SAS RAID controller" on page 207
Ê If the RAID card holder on the defective controller is to be reused, remove it
from the board as described in section "Preparing the SAS RAID controller"
on page 204.
9.3.3.4 Installing the new SAS RAID controller
Ê If applicable, install the RAID card holder on the new SAS RAID controller
as described in section "Preparing the SAS RAID controller" on page 204.
Ê "Installing the SAS RAID controller" on page 203
9.3.3.5 Connecting cables to the expansion card
Ê Connect SAS cables to the SAS RAID controller.
I For a complete cabling overview, please refer to section "Cables
overview" on page 525.
9.3.3.6 Connecting a backup unit to the expansion card
Ê If applicable, connect a BBU to the expansion card as described in sections
"Installing a BBU" on page 227 or "Installing an FBU" on page 241.
9.3.3.7 Concluding steps
Perform the following procedures:
Ê "Installing the air duct" on page 74
Ê "Mounting the server cover" on page 76
Ê "Sliding the server into the rack" on page 80
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 77.
Ê "Connecting the server to the power source" on page 81
Ê "Closing the rack door" on page 84
To Next Page
Loading...
