Fujitsu PRIMERGY RX300 S7 - Replacing the Fan Module; Required Tools; Preliminary Steps

178 Upgrade and Maintenance Manual RX300 S7
System fan
8.1 Replacing the fan module
8.1.1 Required tools
● Preliminary and concluding steps: tool-less
● Replacing the fan module: tool-less
8.1.2 Preliminary steps
Perform the following procedures:
Ê "Opening the rack door" on page 64
Ê "Locating the defective server" on page 56
Ê "Extending the server out of the rack" on page 69
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 70.
Ê "Removing the server cover" on page 72.
Upgrade and Repair Units (URU)
Average task duration: 5 minutes