Fujitsu PRIMERGY RX300 S7 - Preliminary Steps; Removing the TPM

480 Upgrade and Maintenance Manual RX300 S7
System board and components
– TPM bit insert
(
*
)
– thin slotted screw driver ( 2 x 0.4 mm)
(
*
)
(
*
)
For the Japanese market:
– Dedicated TPM screw driver (CWZ8291A)
– TPM module fixing tool (S26361-F3552-L909)
14.3.3.2 Preliminary steps
Perform the following procedures:
Ê "Disabling BitLocker functionality" on page 85
Ê "Opening the rack door" on page 64
Ê "Locating the defective server" on page 56
Ê "Shutting down the server" on page 65
Ê "Disconnecting power cords" on page 66
Ê "Extending the server out of the rack" on page 69
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 70.
Ê "Removing the server cover" on page 72
Ê "Removing the air duct" on page 73
14.3.3.3 Removing the TPM
Ê Remove the TPM board as described in section "Removing the TPM board"
on page 474.
Ê Leave the TPM spacer on the system board when removing the defective
TPM board.