Fujitsu PRIMERGY RX300 S7 - Concluding Steps; Replacing a 2.5-Inch HDD; SSD Module

RX300 S7 Upgrade and Maintenance Manual 157
Hard disk drives / solid state drives
Figure 59: Installing a 2.5-inch HDD / SSD dummy module
Ê Slide the HDD / SSD dummy module into the drive bay until it locks in place.
7.3.3.5 Concluding steps
Perform the following procedures:
Ê "Closing the rack door" on page 84
7.3.4 Replacing a 2.5-inch HDD / SSD module
V CAUTION!
● Only remove an HDD / SSD module during operation if the drive is
not currently being accessed. Observe the indicators for the
corresponding HDD / SSD modules, see "PRIMERGY RX300 S7
Server - Operating manual".
Customer Replaceable Units (CRU)
Average task duration: 5 minutes