Fujitsu PRIMERGY RX300 S7 - Concluding Steps; Replacing the 4 X 2.5-Inch HDD SAS Backplane; Required Tools; Preliminary Steps

164 Upgrade and Maintenance Manual RX300 S7
Hard disk drives / solid state drives
7.4.1.5 Concluding steps
Perform the following procedures:
Ê "Installing the fan box" on page 184
Ê "Installing the air duct" on page 74
Ê "Mounting the server cover" on page 76
Ê "Sliding the server into the rack" on page 80
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 77.
Ê Reinstall all HDD / SSD modules to their original drive bays as described in
section "Installing 3.5-inch HDD modules" on page 140.
Ê "Connecting the server to the power source" on page 81
Ê "Enabling BitLocker functionality" on page 107
Ê "Closing the rack door" on page 84
7.4.2 Replacing the 4x 2.5-inch HDD SAS backplane
7.4.2.1 Required tools
● Preliminary and concluding steps:
– Phillips PH2 / (+) No. 2 screw driver
● Replacing the SAS backplane:
– Phillips PH2 / (+) No. 2 screw driver
7.4.2.2 Preliminary steps
Perform the following procedures:
Field Replaceable Units (FRU)
Average task duration: 10 minutes