354 Upgrade and Maintenance Manual
RX300 S7
Accessible drives
Ê Disconnect the SATA cable (1) and the power cable (2).
Ê Remove the ODD latch from the ODD and fix the ODD latch in the bottom of
the front panel module see figure 198 on page 348.
Figure 204: Installing the ODD dummy
Ê Insert the ODD dummy.
12.6.4 Concluding steps
Perform the following procedures:
Ê "Installing the fan box" on page 184
Ê "Installing the air duct" on page 74
Ê "Mounting the server cover" on page 76
Ê "Sliding the server into the rack" on page 80
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 77.
Ê "Connecting the server to the power source" on page 81
To Next Page
Loading...
