Fujitsu PRIMERGY RX300 S7 - Installing 3.5-Inch HDD Modules; Required Tools; Preliminary Steps; Removing a 3.5-Inch HDD Dummy Module

140 Upgrade and Maintenance Manual RX300 S7
Hard disk drives / solid state drives
7.2.2 Installing 3.5-inch HDD modules
7.2.2.1 Required tools
● Preliminary and concluding steps: tool-less
● Installing a 3.5-inch HDD module: tool-less
7.2.2.2 Preliminary steps
Perform the following procedures:
Ê "Opening the rack door" on page 64
Ê Locate the correct drive bay as described in section "Mounting order for 3.5-
inch HDDs" on page 138.
7.2.2.3 Removing a 3.5-inch HDD dummy module
Figure 43: Removing a 3.5-inch dummy module
Customer Replaceable Units (CRU)
Average task duration: 5 minutes