Fujitsu PRIMERGY RX300 S7 - Starting Up and Operation (Continued); Switching the Server On; Switching the Server Off

76 Upgrade and Maintenance Manual RX300 S7
Basic hardware procedures
4.7 Closing the server
V CAUTION!
● Before attaching the covers, make sure no unnecessary parts or tools
are left inside the server.
● In order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
PRIMERGY RX300 S7 server must not run while the server cover is
removed.
● For further safety information, please refer to chapter "Important
information" on page 43.
4.7.1 Mounting the server cover
Figure 18: Mounting the server cover
Ê Open the locking lever on the top cover.
Ê Fit the server cover on the chassis, aligning it according to the edge guide
marking on the upper server surface.
Ê Lower the server cover onto the chassis.