Fujitsu PRIMERGY RX300 S7 - Removing PSU Modules; Required Tools; Preliminary Steps

RX300 S7 Upgrade and Maintenance Manual 121
Power supply
Ê "Enabling BitLocker functionality" on page 107
6.2 Removing PSU modules
6.2.1 Required tools
● Preliminary and concluding steps: tool-less
● Removing the power supply unit: tool-less
6.2.2 Preliminary steps
Perform the following procedures:
Ê "Opening the rack door" on page 64
Ê "Locating the defective server" on page 56
Ê In non-redundant PSU configurations, shut down the server as described in
section "Shutting down the server" on page 65.
Ê "Disconnecting power cords" on page 66
Customer Replaceable Units (CRU)
Average task duration: 5 minutes