Fujitsu PRIMERGY RX300 S7 - Removing the Defective RDX;DAT Drive; Installing the New RDX;DAT Drive; Concluding Steps

384 Upgrade and Maintenance Manual RX300 S7
Accessible drives
Ê "Removing the server cover" on page 72
Ê "Removing the front cover" on page 501
Ê "Removing the air duct" on page 73
Ê "Removing the fan box" on page 183
12.13.3 Removing the defective RDX/DAT drive
Ê "Removing the drive cage" on page 379
Ê "Removing an RDX/DAT drive out of the cage" on page 380
12.13.4 Installing the new RDX/DAT drive
Ê "Installing an RDX/DAT drive in the cage" on page 372
Ê "Installing the RDX/DAT drive" on page 374
12.13.5 Concluding steps
Perform the following procedures:
Ê "Installing the fan box" on page 184
Ê "Installing the air duct" on page 74
Ê "Installing the front cover" on page 505
Ê "Mounting the server cover" on page 76
Ê "Sliding the server into the rack" on page 80
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 77.
Ê "Connecting the server to the power source" on page 81
Ê "Closing the rack door" on page 84
Ê "Verifying and configuring the backup software solution" on page 98
Ê "Enabling BitLocker functionality" on page 107