Fujitsu PRIMERGY RX300 S7 - Installing a PSU Module; Concluding Steps

120 Upgrade and Maintenance Manual RX300 S7
Power supply
6.1.4 Installing a PSU module
Figure 28: Installing the PSU
Ê Insert the PSU module into its slot.
Ê Push the PSU module into its slot (1) as far as it will go until the locking latch
snaps in place (2).
V CAUTION!
Ensure that the PSU module properly engages in its slot and is locked
in position in order to prevent it from sliding out of the chassis during
transportation.
Ê If applicable, fold down the handle on the PSU module (3).
6.1.5 Concluding steps
Perform the following procedures:
Ê "Connecting the server to the power source" on page 81
Ê "Closing the rack door" on page 84