Fujitsu PRIMERGY RX300 S7 - Re-Installing the TPM; Concluding Steps

RX300 S7 Upgrade and Maintenance Manual 481
System board and components
14.3.3.4 Re-installing the TPM
Figure 303: TPM spacer
Ê The TPM spacer is already present on the system board.
Ê Re-install the TPM board as described in section "Installing the TPM board"
on page 468.
14.3.3.5 Concluding steps
Perform the following procedures:
Ê "Installing the air duct" on page 74
Ê "Mounting the server cover" on page 76.
Ê "Sliding the server into the rack" on page 80
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 77.
Ê "Connecting the server to the power source" on page 81