RX300 S7
Upgrade and Maintenance Manual 219
Expansion cards and backup units
Figure 96: Connecting cable
Ê Connect the loose end of the NCSI sideband cable to the system board:
9.4.1.6 Concluding steps
Perform the following procedures to complete the task:
Ê "Installing the air duct" on page 74
Ê "Mounting the server cover" on page 76
Ê "Sliding the server into the rack" on page 80
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 77.
Ê "Connecting the server to the power source" on page 81.
Ê In order to configure an expansion card that has been installed or replaced,
the card’s Option ROM has to be enabled in the system board BIOS. If
applicable, proceed as described in section "Enabling Option ROM scan" on
page 97.
Connector Cable
NC-SI NCSI sideband cable T26139-Y4015-V101
To Next Page
Loading...
