218 Upgrade and Maintenance Manual
RX300 S7
Expansion cards and backup units
Ê Carefully insert the Modular LAN controller into PCI slot 1 and press down
firmly until it is fully seated in the slot.
Figure 95: Fasten the Modular LAN controller
Ê Fasten the Modular LAN controller with a screw.
Ê If applicable, install SFP+ transceiver modules into the Modular LAN
controller, as described in section "Installing SFP+ transceiver modules" on
page 262.
Connecting the NCSI sideband cable to the system board
I Connecting the NSCI sideband cable is only necessary in order to use
the Modular LAN controller as a shared LAN interface, that allows both,
management and dedicated LAN connections.
If the Modular LAN controller is to be used for dedicated network
connections only, please skip this section.
To Next Page
Loading...
