Fujitsu PRIMERGY RX300 S7 - Installing the Optical Disk Drive (ODD); Required Tools; Preliminary Steps

346 Upgrade and Maintenance Manual RX300 S7
Accessible drives
12.5 Installing the optical disk drive (ODD)
12.5.1 Required tools
● Preliminary and concluding steps: tool-less
● Installing the ODD:
– Phillips PH0 / (+) No. 0 screw driver
12.5.2 Preliminary steps
Perform the following procedures:
Ê "Disabling BitLocker functionality" on page 85
Ê "Opening the rack door" on page 64
Ê "Shutting down the server" on page 65
Ê "Disconnecting power cords" on page 66
Ê "Extending the server out of the rack" on page 69
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 70.
Ê "Removing the server cover" on page 72
Ê "Removing the air duct" on page 73
Ê "Removing the fan box" on page 183
Upgrade and Repair Units (URU)
Average task duration: 10 minutes