Fujitsu PRIMERGY RX300 S7 - Installing a 2.5-Inch HDD; SSD Dummy Module

156 Upgrade and Maintenance Manual RX300 S7
Hard disk drives / solid state drives
Figure 58: Removing a 2.5-inch HDD / SSD module
Ê Pull the HDD / SSD module completely out of its bay.
7.3.3.4 Installing a 2.5-inch HDD / SSD dummy module
V CAUTION!
If the removed HDD / SSD module is not replaced immediately, always
replace a dummy module into the unused HDD / SSD bay to comply with
applicable EMC regulations and satisfy cooling requirements.