154 Upgrade and Maintenance Manual
RX300 S7
Hard disk drives / solid state drives
Ê Insert the HDD module into a drive bay and carefully push back as far as it
will go (1).
Ê Close the locking lever to lock the hard disk drive in place (2).
7.3.2.5 Concluding steps
Perform the following procedures:
Ê "Performing a RAID array rebuild" on page 108
Ê "Closing the rack door" on page 84
7.3.3 Removing 2.5-inch HDD / SSD modules
7.3.3.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Removing a 2.5-inch HDD / SSD module: tool-less
7.3.3.2 Preliminary steps
Perform the following procedures:
Ê Ensure that the HDD / SSD module to be removed is not combined into a
RAID array. If the drive is part of a RAID array, you first need to delete the
array using ServerView RAID Manager.
V CAUTION!
All data on all HDDs / SSDs in the array will be lost! Be sure to back
up your data before deleting a RAID array.
I For further information, please refer to the "ServerView Suite RAID
Management" user guide, available online at
http://manuals.ts.fujitsu.com.
Customer Replaceable Units (CRU)
Average task duration: 5 minutes
To Next Page
Loading...
