444 Upgrade and Maintenance Manual
RX300 S7
Front panel
13.3.3.3 Removing the front panel module
Ê Remove the front panel module as described in section "Removing the front
panel module" on page 410.
13.3.3.4 Removing the front LAN connector
Ê Remove the defective front LAN connector as described in section
"Removing the front LAN connector" on page 439.
13.3.3.5 Installing the new front LAN connector
Ê Install the new front LAN connector as described in section "Installing the
front LAN connector" on page 428.
13.3.3.6 Re-installing the front panel module
Ê "Installing the front panel module" on page 413
13.3.3.7 Concluding steps
Perform the following procedures:
Ê "Installing the fan box" on page 184
Ê "Installing the air duct" on page 74
Ê "Mounting the server cover" on page 76
Ê "Sliding the server into the rack" on page 80
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 77.
Ê "Connecting the server to the power source" on page 81
Ê "Closing the rack door" on page 84
Ê "Looking up changed MAC / WWN addresses" on page 108
Ê "Updating the NIC configuration file in a Linux environment" on page 105
Ê If applicable, restore LAN teaming configurations as described in section
"After replacing / upgrading LAN controllers" on page 112.
Ê "Enabling BitLocker functionality" on page 107
To Next Page
Loading...
