Fujitsu PRIMERGY RX300 S7 - Replacing the Power Backplane; Required Tools; Preliminary Steps

RX300 S7 Upgrade and Maintenance Manual 129
Power supply
6.5 Replacing the power backplane
6.5.1 Required tools
● Preliminary and concluding steps: tool-less
● Replacing the power supply unit: tool-less
6.5.2 Preliminary steps
Perform the following steps:
Ê "Opening the rack door" on page 64
Ê "Locating the defective server" on page 56
Ê "Disabling BitLocker functionality" on page 85
Ê "Shutting down the server" on page 65
Ê "Disconnecting power cords" on page 66
Ê "Extending the server out of the rack" on page 69
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 70.
Ê "Removing the server cover" on page 72
Ê "Removing the air duct" on page 73
Field Replaceable Units (FRU)
Average task duration: 10 minutes