EasyManua.ls Logo

Fujitsu PRIMERGY RX300 S7 - Required Tools; Preliminary Steps

Fujitsu PRIMERGY RX300 S7
560 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
452 Upgrade and Maintenance Manual
RX300 S7
System board and components
Do not throw batteries into the trash can. Lithium batteries must be
disposed of in accordance with local regulations concerning special
waste.
For further safety information, please refer to section "Environmental
protection" in the PRIMERGY RX300 S7 Operating Manual.
Ensure to insert the CMOS battery with the positive pole facing
up!
14.1.1 Required tools
Preliminary and concluding steps: tool-less
Replacing the battery: tool-less; recommended: tooth pick
14.1.2 Preliminary steps
Perform the following procedures:
Ê "Opening the rack door" on page 64
Ê "Locating the defective server" on page 56
Ê "Shutting down the server" on page 65
Ê "Disconnecting power cords" on page 66
Ê "Extending the server out of the rack" on page 69
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 70.
Ê "Removing the server cover" on page 72
Ê "Removing the air duct" on page 73

Table of Contents

Other manuals for Fujitsu PRIMERGY RX300 S7

Related product manuals