84 Upgrade and Maintenance Manual
RX300 S7
Basic hardware procedures
4.11 Concluding software tasks
Ê Perform the following software tasks to put the server back in operation:
– "Resetting the boot retry counter" on page 99
– "Verifying the system time settings" on page 103
– "Viewing and clearing the System Event Log (SEL)" on page 104
– "Updating the NIC configuration file in a Linux environment" on
page 105
– "Enabling BitLocker functionality" on page 107
– "Performing a RAID array rebuild" on page 108
– "Looking up changed MAC / WWN addresses" on page 108
4.12 Closing the rack door
The PRIMECENTER M1 rack is equipped with a split front door. The left-hand
door contains an interlocking system that can be locked and opened with a key.
Optionally, a revolving door knob can be mounted for key-less locking. To close
and lock the rack, proceed as follows:
Ê Close the right-hand door first, then the left-hand door.
Ê Insert and turn the key clockwise by 180 degrees.
If applicable, turn the door knob clockwise by 180 degrees.
I For further information, refer to the "PRIMECENTER Rack System"
assembly guide available online at http://manuals.ts.fujitsu.com .
To Next Page
Loading...
