522 Upgrade and Maintenance Manual
RX300 S7
Conversion configurations
Figure 343: Connecting SAS cables
Ê Connect cable C5 to the connector X17 of the 12x 2.5-inch SAS
backplane (1).
Ê Connect cable C4 to the connector X15 of the 12x 2.5-inch SAS
backplane (2).
Ê Connect the cable C9 to X1 of the 12x 2.5-inch SAS backplane (3) and the
connector MLC1 of the SAS controller (4).
Ê Connect the cable C9 to X2 of the 12x 2.5-inch SAS backplane (5) and the
connector MLC2 of the SAS controller (6).
Ê Route the cables as shown.
15.3.6 Configuration 4 to configuration 8
Ê Convert Configuration 4 to configuration 7 see section "Configuration 4 to
configuration 7" on page 520.
Ê Replace multicage with the panelhousing and a HDD cage as described in
section "Replacing the front cages" on page 517.
Ê Connect cable C7 from connector X1 of the 4x 2.5-inch SAS backplane to
connector X3 of the 12x 2.5-inch SAS backplane
To Next Page
Loading...
