RX300 S7
Upgrade and Maintenance Manual 395
Accessible drives
Ê "Installing the front cover" on page 505
Ê "Mounting the server cover" on page 76
Ê "Sliding the server into the rack" on page 80
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 77.
Ê "Connecting the server to the power source" on page 81
Ê "Opening the rack door" on page 64
Ê "Verifying and configuring the backup software solution" on page 98
Ê "Enabling BitLocker functionality" on page 107
12.15 Removing an LTO drive in 2.5-inch version
12.15.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Removing accessible drives:
– Phillips PH2 / (+) No. 2 screw driver
12.15.2 Preliminary steps
Perform the following procedures:
Ê "Disabling BitLocker functionality" on page 85
Ê "Opening the rack door" on page 64
Ê "Locating the defective server" on page 56
Upgrade and Repair Units (URU)
Average task duration: 10 minutes
To Next Page
Loading...
