Fujitsu PRIMERGY RX300 S7 - Removing Onboard SAS Enabling Key; Concluding Steps

RX300 S7 Upgrade and Maintenance Manual 485
System board and components
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 70
Ê "Removing the server cover" on page 72
Ê "Removing the air duct" on page 73.
14.4.2.3 Removing onboard SAS enabling key
Figure 306: Removing onboard SAS enabling key
Ê Firmly pull up on the release lash until the onboard SAS enabling key pops
out of its connector.
14.4.2.4 Concluding steps
Perform the following procedures:
Ê "Installing the air duct" on page 74
Ê "Mounting the server cover" on page 76