558 Upgrade and Maintenance Manual
RX300 S7
Appendix
17.4 Minimum startup configuration
If the server does not start up or other problems occur, it may be necessary to
take the system down to its most basic configuration in order to isolate the
defective component.
The minimum startup configuration consists of the following components and
cables:
Ê "Shutting down the server" on page 65
Ê "Disconnecting power cords" on page 66
Ê Take the system down to its minimum startup configuration.
Ê "Connecting the server to the power source" on page 81
Ê Connect a keyboard, mouse and display to the server.
Ê "Switching on the server" on page 82
Field Replaceable Units (FRU)
Component Notes
System board no TPM, UFM or expansion cards installed
CPU with CPU heat sink
1 memory module installed in DIMM slot 1A
Front panel module without connected front LAN module
Power supply unit
Table 11: Minimum startup configuration - components
Cable Notes
Front panel cable
Power cable
Table 12: Minimum startup configuration - cables
To Next Page
Loading...
