Fujitsu PRIMERGY RX300 S7 - Installing an RDX;DAT Drive in the Cage

RX300 S7 Upgrade and Maintenance Manual 359
Accessible drives
12.8.3 Installing an RDX/DAT drive in the cage
I – A drive cage is installed
Ê Remove the drive cage see section "Removing the drive cage" on
page 366.
Ê Remove the dummy drive.
– 3.5-inch HDDs or 3.5-inch HDD dummy are installed
Ê Remove HDD/HDD dummy 5 and 6 see section "Removing a 3.5-
inch HDD dummy module" on page 140
Figure 206: Inserting the RDX/DATdrive
Ê Insert the RDX/DAT drive into the cage and push in.