Fujitsu PRIMERGY RX300 S7 - Replacing the Onboard SAS Enabling Key; Required Tools; Preliminary Steps

486 Upgrade and Maintenance Manual RX300 S7
System board and components
Ê "Sliding the server into the rack" on page 80
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 77.
Ê "Connecting the server to the power source" on page 81
Ê "Enabling BitLocker functionality" on page 107.
14.4.3 Replacing the onboard SAS enabling key
14.4.3.1 Required tools
● Preliminary and concluding steps: tool-less
● Replacing the onboard SAS enabling key: tool-less
14.4.3.2 Preliminary steps
Perform the following procedures:
Ê "Disabling BitLocker functionality" on page 85
Ê "Locating the defective server" on page 56.
Ê "Shutting down the server" on page 65
Ê "Disconnecting power cords" on page 66
Ê "Extending the server out of the rack" on page 69
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 70.
Ê "Removing the server cover" on page 72
Ê "Removing the air duct" on page 73
Field Replaceable Units (FRU)
Average task duration: 5 minutes