RX300 S7
Upgrade and Maintenance Manual 495
System board and components
I For a detailed description, please refer to section "Onboard settings"
on page 548.
14.5.4.2 Swapping processors
Preparing the processor socket load plates on the new system board
Ê "Opening the load plate of the processor socket" on page 292
Removing processors from the defective system board
Ê Carefully remove the processors from their sockets on the defective system
board as described in "Removing the processor" on page 307.
V Remove and reinstall one processor at a time. Do not remove the
second processor from the defective system board until the first
processor has been installed on the new system board.
Installing processors on the new system board
Ê Install the processors on the new system board as described in "Installing
the processor" on page 296.
Installing protective socket covers on the defective system board
I Since the defective system board is sent back for repair, protect the
delicate processor socket springs with a socket cover.
Ê "Installing the protective cover" on page 309
14.5.5 Concluding steps
Ê Reconnect all cables to the system board. For a complete cabling overview,
please refer to section "Cables overview" on page 525.
Ê Reinstall all remaining system board components as shown in the related
sections:
– SAS RAID controller: see section "Installing the SAS RAID controller" on
page 203
– Onboard SAS enabling key: see section "Installing the onboard SAS
enabling key" on page 482
To Next Page
Loading...
