RX300 S7
Upgrade and Maintenance Manual 255
Expansion cards and backup units
9.7.1.2 General instructions
Ê Place the controller on the mounting tabs on the slot bracket.
Ê Secure the slot bracket to the controller with two M3 x 4.5 mm screws.
Removal is carried out in reverse order.
I For a more detailed description on how to install a slot bracket on a
controller, please refer to section "Network adapter D2735" on page 255.
9.7.1.3 Network adapter D2735
Figure 121: Network adapter D2735 - Mounting the slot bracket (A)
Ê Place the controller on the mounting tabs on the slot bracket (1).
Ê Carefully shift the slot bracket towards the controller (2) until the plug shells
engage with the cut-outs in the slot bracket connector panel (see close-up).
To Next Page
Loading...
